This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.
Edelbrock 3706 - Performer Manifold, Chevrolet Small Block, 87-95 cast Iron Heads, EGR
Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS.
Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure a proper seal.
DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Choke plate # 8901 included
See adapter # 8035 for the clamp-on EGR valve.
With carb # 1400 & # 3701, EGR spacer # 1476 is required.
The # 3706 has no provision for exhaust heated chokes.
Even though manifolds are compatible with EGR systems, this does not mean they are legal for use on emissions controlled vehicles. Check local laws for legality.
Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Edelbrock 3706 - Performer Manifold, Chevrolet Small Block, 87-95 cast Iron Heads, EGR
Edelbrock Part # 3706 Performer EGR intake manifold is designed for street 262-400 c.i.d. Chevy V8's that have heads with canted center bolt holes, 1987-1995. This intake manifold accepts late-model water neck, air-conditioning, alternator, H.E.I. and have rear water crossovers. For 1987-95 stock aluminum heads use #3701. Will not fit Chevrolet Bowtie or LT1 heads.
For idle to 5500 RPM street-driven performance
Dual-plane low-rise intake with 180-Degree firing order
Patented runner design ensures broad torque curve
Excellent throttle response and mid-range power
Accepts late-model choke, water neck and HEI ignition
Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS.
Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure a proper seal.
DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
Choke plate # 8901 included
See adapter # 8035 for the clamp-on EGR valve.
With carb # 1400 & # 3701, EGR spacer # 1476 is required.
The # 3706 has no provision for exhaust heated chokes.
Even though manifolds are compatible with EGR systems, this does not mean they are legal for use on emissions controlled vehicles. Check local laws for legality.
Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
