Edelbrock 3712 - Performer Plus Cam & Lifters Kit, Oldsmobile 350-403

€453.00 *

Prices incl. VAT plus shipping costs*

In Stock - Ready to ship,
Delivery time appr. 1-3 Workdays

  • EDL-3712
  • Produces 330 ft.-lbs. when matched with #3711 intake and stock heads. May require longer than stock pushrods. Will not fit 1966 & earlier.
Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match... more
Edelbrock 3712 - Performer Plus Cam & Lifters Kit, Oldsmobile 350-403

Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match with Performer manifolds for vehicles operating from off-idle to 5500 rpm. They are smooth idling cams for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. These popular Performer-Plus camshafts for Small-Block Chevy are 50-state street legal.

  • Designed for optimum torque and acceleration
  • Maximum performance from idle through mid-range
  • Matched to Edelbrock Performer intakes
  • Includes hydraulic lifters and assembly lube
  • Major improvement in throttle response and torque
  • Use for daily drivers/trucks/vans/RVs/4x4s
  • Take the guesswork out of camshaft selection
Car/Engine: Oldsmobile
Engine Notes: 350-403 V8
Camshaft Type: Hydraulic Flat Tappet
Serie: Performer-Plus
RPM Range: Idle-5500
Duration @ .050 Int/Exh: 204°/214°
Lift @ Valve Int/Exh: .449"/.473"
Lobe Separation: 114°
Intake Center Line: 106°
Idle Vacuum @ 1000 RPM: 16"
Related links
Documentation... more
Installation Notes
    • Recommended Valve Springs for OEM heads: Edelbrock part # 5812
    • May require longer than stock pushrods.
    • Will not fit 1966 & earlier.
    • In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.
    • Oil/additive must contain Zinc designed for use with flat tappet camshafts.
    • Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
    • Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Read, write and discuss reviews... more
Customer review for "Performer Plus Cam & Lifters Kit, Oldsmobile 350-403"
Write an review
Reviews will be activated after verification.

The fields marked with * are required.

I have read the data protection information.

Viewed