Gooze 1109KIT - Triple Deuce 9-Super-7 Manifold/Carb Kit, Ford Flathead 1949-53

This tri power kit uses the famous Edelbrock 3x2 intake with Speedway's 9 Super 7® carbs. It has progressive linkage to give you good driveability and economy, but power when you need it. Includes three carbs, the intake, linkage kit and Studs. Assembly required. The 9 Super 7® Carb ® makes setting up a multiple carburetor induction system easier than when Strombergs were available new. All that's required to do so with our kits is a Uni-Syn syncing tool and a little patience. Our 3 Carb kits come with one primary carburetor and two secondary carburetors.

• For 1949-53 Ford/Mercury Flathead
• Front 1-3/8" diameter oil fill
• 1-1/4" road draft bosses and a raised fuel pump boss
• Carb spacing is 5-1/8"
• Manifold height: A-3.66", B-3.66"
• Port exit dimensions: 1.3" x 1.7"
• Three Deuce carburetor setups come with two "secondary" carbs for front and rear intake position and one "primary" carb for central/middle position
• All-new tooling for crisp, flawless castings
• New aluminum base assembly allows for cooler fuel temps and better fuel efficiency as compared to the original cast iron design
• Stainless steel screws and hardware
• Original troublesome needle and seat replaced by a Grose-style fuel inlet valve to better cope with higher fuel pressures and improved high speed running 
• Will not stick or dribble like the old Viton-tipped needle and seat setups
• Extended brass throttle shaft to simplify multi-carb linkage
• Primary Carb - (1) Middle Position
  • Choke assembly, accelerator pump, and jets have all been faithfully retained and accept standard Stromberg parts
• Secondary Carb - (2) Front and Rear Position
  
  • Special base plate with no idle circuits or choke linkage
  • Special butterflies and shafts installed
  • Works best with progressive linkage
  • Idle only off the center or main carburetor
  • No more plug foul