inkl. MwSt. zzgl. Versandkosten
In Stock - Ready to ship,
Estimated Ship Date: Friday 3th May
- Artikel-Nr.: EDL-85332
- Notes:
Edelbrock E-Series Cylinder Head Bolt Kit #85332 is designed for use on Jeep 4.0L inline six-cylinder engines using ½-inch head bolts. This high-quality E-Series bolt kit will pair perfectly with Edelbrock’s Jeep Cylinder Head #50159 and #50169 and will also fit the 4.2L inline six-cylinder engine if using Edelbrock heads. E-Series bolts have a yield tensile strength of 190,000 PSI for strong and reliable loading with generous filleting throughout to eliminate stress risers. Bolt threads are rolled after heat-treating for superior form and strength, while a small hex head provides extra space for socket clearance in tight situations. E-Series Cylinder Head Bolts have a durable black oxide finish with sealer and come with the distinctive Edelbrock “E” stamped into the head.
- Small hex head provides extra socket clearance
- Durable black oxide finsh
- Washers included
- Rated at 190000 psi
- Lenghts: (7) 3.75 in, (7) 4.50 in
Serie: | E-Series |
Car/Engine: | Jeep |
Engine Notes: | 4.0L In-Line Six |
-
- The Edelbrock #85332 is made specifically for Jeep 4.0L using ½-inch head bolts.
- Installation is the same as for original equipment cylinder heads.
- Consult service manual for specific procedures, if necessary.
- Be sure that the surface of the block and the surface of the head are thoroughly cleaned to remove any oily film before installation.
- Use alcohol or lacquer thinner on a lint-free rag to clean. Apply oil or suitable thread lubricant to head bolt threads and the underside of bolt heads and washers.
- Torque cylinder head bolts in three steps following the factory tightening sequence